Home > Metal Forming Accessories > Filler Forms

Specs & Sizes for dee’s Filler Forms

Straight Filler Forms

They are made from 12-gauge steel for heights from 4" to 7-1/2" and 10-gauge steel for forms 8" and higher. All are available in standard 5' sections and up to 10' by request. Our straight filler forms are manufactured with a top rail of ~2-1/8" inside dimension and no bottom rail allowing them to easily slip over the 2" rail of the straight flatwork forms they are used to connect.

Straight filler forms can also be used to connect dee's forms to all other competitors' forming systems that utilize a 2" rail.

Inverted Filler Forms

dee inverted filler forms are identical to dee's straight filler forms, except that they are placed on the base of the straight forms rather than on the top.

The inverted filler form is held to line by an attached stake pocket or with the use of the filler form locks.

Flexible Filler Forms

dee flexible filler forms are used to bridge the odd lengths between forms or at the end of a flatwork placement. They are manufactured with 13-gauge spring steel with attached end angle, three loose stake pockets and locking clamp. They are available from 4" - 24" lengths.

Place your mouse over a product number in the table to reveal the product image.

Description	Product #
Straight filler form	255	View Part
Inverted filler form	256	View Part
Flexible filler form	525	View Part

STRAIGHT Odd length gap filling between straight forms	Saves time and waste removal expense
INVERTED Provides absolutely smooth surface for the screed to ride on	Reduces fine finishing time
FLEXIBLE Odd length gap filling between radius forms	Saves time and waste removal expense